The status indicator is set to “on”. The battery life when using the status indicator will only get up to 3 months.

This can be turned off by the slide switch on the circuit board as shown in the picture below. Remove the battery first, adjust the switch, replace the battery and rearm.

With status off, battery life can last for up to 12 months.

Note: Use name brand alkaline battery. If unit has gotten wet, it will drain the battery.

Key stop being used. This is a safety feature that will not allow a key holder to walk away from the device with their keys without the alarm being armed.

Status indicator set to “Off” by default. Yellow slide switch for status indicator needs to be slid to on. The unit must be off and battery removed before the change can be made.

Status indicator set to “Off” by default. Yellow slide switch for status indicator needs to be slid to on. The unit must be off and battery removed before the change can be made.

The 9V battery needs to be replaced with a name brand, alkaline battery.

The device mounts to the wall and 2 external magnetic switches need to be used.  The switches are wired in series and connected to the green terminal block on the top of the board.  The JP1 jumper wire also needs to be cut on the board.

Disarm the device by turning your key clockwise. Look on the circuit board near the sticker saying “500”, there are two metal prongs with white lettering near them saying ‘Mag Handing’. Short them together using something metal like a screwdriver or a key. The unit should beep 5 times.  Reinstall the device with the door open, arm by turning the key counter-clockwise and close the door. You should hear 1 chirp and then the device should start the 15 second arming delay indicated by rapid flashing of green light, followed by 3 chirps, indicating that it is armed.

If JP1 is cut on the board, the unit is made to mount on the wall and use a external magnetic switch.

Please refer to the installation instructions for more information on how to re-hand your device

Disarm the device by turning your key clockwise. Look on the circuit board near the sticker saying “500”, there are two metal prongs with white lettering near them saying ‘Mag Handing’. Short them together using something metal like a screwdriver or a key. The unit should beep 5 times.  Reinstall the device with the door open, arm by turning the key counter-clockwise and close the door. You should hear 1 chirp and then the device should start the 15 second arming delay indicated by rapid flashing of green light, followed by 3 chirps, indicating that it is armed.

If JP1 is cut on the board, the unit is made to mount on the wall and use a external magnetic switch.

Please refer to the installation instructions for more information on how to re-hand your device

May be set to auto rearm(non-extended bypass) and the magnet on the frame not aligned properly.

Re-hand the device and ensure door stays closed throughout entire arming process.