Refer to the installation instructions and follow the instructions

The key is turned to the armed position, but the device does not sound when the door opens and the door prop time expires.

Handed to wrong side.

Unplug and reinsert battery, 4 chirps is in door prop mode.
5 chirps, the unit is not handed.  Confirm the magnet is aligned correctly.

Disarm the device by turning your key clockwise. Look on the circuit board, there are to metal prongs with white lettering  saying ‘Mag Handing’. Short them together using metal like a screwdriver or the key. The unit should chirp 5 times.  Reinstall the device with the door open, turn device to on, and close door. You should hear 1 chirp and then the device is ready.

If JP1 is cut on the board, the unit is made to mount on the wall and use a external magnetic switch.

The status indicator is set to “on”. The battery life when using the status indicator will only get up to 3 months.

This can be turned off by the slide switch on the circuit board as shown in the picture below. Remove the battery first, adjust the switch, replace the battery and rearm.

With status off, battery life can last for up to 12 months.

Note: Use name brand alkaline battery. If unit has gotten wet, it will drain the battery.

Key stop being used. This is a safety feature that will not allow a key holder to walk away from the device with their keys without the alarm being armed.

Status indicator set to “Off” by default. Yellow slide switch for status indicator needs to be slid to on. The unit must be off and battery removed before the change can be made.

Status indicator set to “Off” by default. Yellow slide switch for status indicator needs to be slid to on. The unit must be off and battery removed before the change can be made.