Status indicator set to “Off” by default. Yellow slide switch for status indicator needs to be slid to on. The unit must be off and battery and hardwired power removed before the change can be made.
Status indicator set to “Off” by default. Yellow slide switch for status indicator needs to be slid to on. The unit must be off and battery and hardwired power removed before the change can be made.
Top or Bottom Rods may need adjustment.
To identify part numbers, drawings can be found in the instructions and on parts lists.
A distributor can also be found for you by calling us.
You can also call one of our go to parts distributors:
Door Service – 314-487-0800 Ext. 2
Dead or weak battery.
Battery not secured to connector correctly.
Battery connector or wires damaged.
No AC power.
Install new battery, LED’s should flash and the siren beep once. Secure battery correctly. Verify power from transformer and check for correct voltage at connector P2. AC powered unit gives a low battery indication.
Battery not installed. OR Low battery
Install battery. If battery is not desired, disconnect power and slide the ‘Dis Lo Bat IND’ switch to ‘ON’ position.
Status indicator set to “Off” by default. Yellow slide switch for status indicator needs to be slid to on. The unit must be off and battery removed before the change can be made.
Status indicator is set to “Off” by default. The yellow slide switch for status indicator needs to be slid to on. The unit must be off and battery removed before the change can be made.
The actuator is sticking to the micro switch. Call Detex – 800-729-3839
Follow these instructions:
