Categories: EAX-3500 FAQFAQ

I can’t add time to the bar display

Turn the key counter clockwise to reset and release the key. Then push the time button to increment bar display.

If you hold the key in the reset position and don’t release it and push the time button to increment, the display will start to add time but will alarm every time the button is pushed.

Pushing and holding the button to add time the bar graph starts to increment part of the way and the alarm sounds. Also, pushing the button 1 step at a time sounds the alarm.

The cam lever is holding in the micro switch and not returning back down.

Corrective action would be:

Loosen the two cam screws a bit they could be over tightened causing binding. If there is still an issue replace the cam, part number 102680.

Aubrey Mahan

Recent Posts

Detex Nominated for Outstanding Manufacturing Mentor Award by Skillpoint Alliance

New Braunfels, TX — Detex Corporation is honored to announce its nomination for the Outstanding…

1 week ago

The Importance of Door Hardware Maintenance

Regular door hardware maintenance is essential for ensuring safety, security, and compliance with building codes.…

2 weeks ago

I have input power, but no output power

If there are wires landed on the J2 fire loop, check the LED2. If it…

4 weeks ago

My latch light never comes on. It stays on close speed

The arm may have been installed wrong. To reinstall the arm, remove from spindle and…

4 weeks ago

How do I change the door prop time?

Refer to the installation instructions and follow the instructions

4 weeks ago